Skoda Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing crankshaft-belt pulley >
< Removing and installing V-ribbed belt for vehicles with air conditioning system
Octavia Mk2
Power unit
2.0/103; 125 kW TDI CR Engine (1st generation)
Enginecrankshaft group, pistons / Removing and installing a V-ribbed belt and a toothed belt
Removing and installing tensioning element for V-ribbed belt
Removing and installing tensioning element for V-ribbed belt
Removing and installing tensioning element for V-ribbed belt
Removing
–
Remove V-ribbed belt from tensioning element
→ Chapter
.
–
Remove the right charge air hose, to do so loosen the hose clamp
-2-
and slightly raise the clamp
-1-
.
–
Remove fan shroud with radiator fans
→ Chapter
.
–
Release screws
-arrows-
.
–
Expose coolant hose
-3-
.
–
Loosen hose clamp
-2-
.
–
Disconnect plug
-1-
at the charge pressure sender -G31- and remove the right charge air pipe.
–
Unscrew screw
-2-
and remove tensioning element
-1-
from V-ribbed belt.
Install
Installation is performed in the reverse order, pay attention to the following points:
t
Tightening torques:
→ Chapter
.
–
Replace the screw of the tensioning element for the V-ribbed belt.
–
Install the V-ribbed belt
→ Chapter
.
Power unit
2.0/103; 125 kW TDI CR Engine (1st generation)
Enginecrankshaft group, pistons / Removing and installing a V-ribbed belt and a toothed belt
Removing and installing tensioning element for V-ribbed belt
Removing and installing crankshaft-belt pulley >
< Removing and installing V-ribbed belt for vehicles with air conditioning system