skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing V-ribbed belt for vehicles without air conditioning system > < Removing and installing a V-ribbed belt and a toothed belt

Octavia Mk2

V-ribbed belt drive and bracket for auxiliary units, vehicles with air conditioning system - Summary of components
   
V-ribbed belt drive and bracket for auxiliary units, vehicles with air conditioning system - Summary of components
1 - V-ribbed belt
q   removing and installing → Chapter
q   check for wear
q   mark the direction of rotation with chalk or a felt-tip pen before removing
q   do not kink
q   pay attention to the correct position on the belt pulley when installing it.
2 - Tensioner for V-ribbed belt
q   removing and installing → Chapter
3 - Crankshaft-belt pulley
q   with vibration damper
q   pay attention to correct installation position → Fig.
q   removing and installing → Chapter
4 - 10 Nm + torque a further 90° (1/4 turn)
q   replace
5 - 23 Nm
6 - Fitting sleeve
q   pay attention to correct fit in the bracket for auxiliary units
q   The dowel sleeve is located in the top right screw hole → Fig.
7 - Screw
q   Tightening torque: → Chapter
8 - 50 Nm + torque a further 90° (1/4 turn)
q   replace
9 - Guide pulley
q   for toothed belt
10 - 20 Nm
11 - Guide pulley
q   for toothed belt
12 - Bracket for auxiliary units
q   order of tightening → Fig.
q   removing and installing:
t  Octavia II, Yeti → Chapter
t  Superb II → Chapter
q   a lifting eye is located on the bracket at the front left, similar to the attachment of the front left lifting eye at the cylinder block → Chapter
13 - High pressure pump
q   removing and installing → Chapter
14 - 20 Nm + torque a further 180° (1/2 turn)
q   replace
15 - Screw
q   replace
q   tightening order and tightening torque → Fig.
16 - AC generator
q   removing and installing → Electrical System; Rep. gr.27
17 - 23 Nm
18 - AC compressor
q   removing and installing → Heating, Air Conditioning; Rep. gr.87
19 - 23 Nm
20 - Fitting sleeve
q   pay attention to correct fit in the holder

   
Fitting position of the crankshaft-belt pulley
l  The hole -arrow- in the crankshaft belt pulley must be positioned above the peg on the crankshaft timing belt sprocket.
  A13-0134
Bracket for auxiliary units - tightening order and tightening torques
l  A dowel sleeve must be located between the bracket for auxiliary units and the cylinder block in the area of the screw hole -6-.
–  Insert new screws for the bracket for auxiliary units as follows:
t  Screws -1- and -2- M10x52
t  Screws -3- and -4- M10x30
t  Screws -5- and -6- M10x60
–  Gradually tighten the screws for the bracket for auxiliary units in the sequence -1...6-:
1.  Tighten all the screws by hand.
2.  Tighten all screws to 40 Nm.
3.  Turn the screws -3- and -4- a further 45°.
4.  Turn the screws -1, 2, 5 and 6- a further 90°.
  S13-0706

Removing and installing V-ribbed belt for vehicles without air conditioning system > < Removing and installing a V-ribbed belt and a toothed belt