skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Hose connections with screw clamps > < Hose connections

Octavia Mk2

Assembly of hose connections with push-fit couplings
Assembly of hose connections with push-fit couplings
  Caution
The gasket ring for the push-fit coupling can be damaged, if the securing clamp is in the lock position during the assembly. This could result in a leakage. Observe the assembly instruction.
Removing
   
–  Release the push-fit coupling by pulling the securing clamp -arrow-. Disconnect hose/pipe without auxiliary tool.
Install
–  When replacing the gasket ring, place the gasket ring in the groove of the charge air hose. Make sure that the gasket ring is fully seated all around in the groove and not twisted.
–  Oil sealing surface and gasket ring.
  N21-0184
–  Put the securing clamp into the release position -1-.
–  Insert the charge air hose up to the stop into the coupling.
–  Put the securing clamp into the lock position -2- and then press down once again the charge air hose.
–  Check for correct seating and the correct locking in place of the push-fit coupling by pulling on the hose.
  N21-10133

Hose connections with screw clamps > < Hose connections