Skoda Workshop Service and Repair Manuals

Removing and installing air filter housing Special tools and workshop equipment required t  Pliers for spring strap clamps Removing –  Remove engine cover → Chapter.

–  Remove cover for connection fitting, to do so release lateral retaining clasps -arrows-.

–  Release screws -arrows- for connection fitting -1- and take connecting hose -2- out of the guide.

–  Press in pegs -1- and -3- and pull off connecting hose -4- from air filter housing -2-.

–  Unplug connector -1- from air mass meter -G70-. –  Detach vacuum hose -3- and intake hose -2-. –  Slacken screw -4- and remove air filter housing. Remove intake hose   Note Due to the poor access of the pliers for spring strap clips to the bottom intake hose it is preferable to remove the connection fitting from the exhaust turbocharger.

–  Unclip vacuum lines -2- and -3- from intake hose. –  Remove connecting pipe for crankcase ventilation -1-.

–  Release screw -2-. –  Swivel connection fitting -3- in -direction of arrow A- and remove with the intake hose -1-. Install Installation is performed in the reverse order, pay attention to the following points:   Note t  Replace O-ring. t  When installing the inlet connection -3- at the exhaust gas turbocharger, make sure that the inlet connection is correctly seated on the bolt -arrow B-.