Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Power unit | 2.0/103; 125 kW TDI CR Engine (1st generation) | Fuel supply, gas operation | Accelerator control | Removing and installing accelerator pedal module | Disconnect connector for accelerator pedal module and fit on

Disconnect connector for accelerator pedal module and fit on

Note

The plugs for the accelerator pedal module which are inserted, must be disconnected and fit on in a different manner.

Disconnect connector 1K0 973 706

–	Slightly press the piston slide valve -A- (grey) in -direction of arrow 1- and push it up to the stop in -direction of arrow 2-.

–	Hold the piston slide valve in this position and disconnect the socket housing -B- in -direction of arrow 3-.

The piston slide valve -A- is pushed into the bottom position.

Fit on connector 1K0 973 706

–	Push the socket housing -B- in -direction of arrow- until the piston slide valve can be heard to lock in place.

The piston slide valve -A- moves automatically upwards.

Note

For safety reasons, check the connector for secure catch by tightening it in the opposite direction.

Disconnect connector 8K0 973 706

–	Pull out the piston slide valve -A- (red) up to the stop in -direction of arrow-.

–	Press the piston slide valve in -direction of arrow 2- and disconnect the socket housing -B- in -direction of arrow 3-.

The piston slide valve -A- remains in the top position.

Fit on connector 8K0 973 706

–	Push the socket housing -B- up to the stop in -direction of arrow 1-.

–	Slightly press the piston slide valve in -direction of arrow 2- and push it in -direction of arrow 3-.

The piston slide valve -A- can only be pushed down if the socket housing was pushed up to the stop.

Note

For safety reasons, check the connector for secure catch by tightening it in the opposite direction.

Skoda Workshop Service and Repair Manuals