skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Accelerator control > < Check voltage consumption of the fuel pump

Octavia Mk2

Removing and installing additional fuel pumpV393
Removing and installing additional fuel pump -V393-
  Note
t  Observe safety measures when working on the fuel system → Chapter.
t  Observe rules for cleanliness → Chapter.
t  The additional fuel pump -V393- is only supplied as a spare part complete with the bracket.
Removing
   
–  Disconnect plug connection -2- at exhaust gas pressure sensor 1 -G450-.
–  Screw out screw -3- and remove bracket with exhaust gas pressure sensor 1 -G450- from the bracket for the additional fuel pump in -direction of arrow-.
–  Place the bracket with the exhaust gas pressure sensor 1 -G450- to the rear.
  Caution
Risk of damage!
The exhaust gas pressure sensor 1 -G450- is very sensitive and must therefore not touch somewhere when laying it down with the bracket.
  A26-10722
–  Unhook the fuel hoses -1, 2, 3- on the bracket and remove the bracket -4-.
  A20-10394
–  Unplug connector -1-.
–  Unscrew screws -3 and 4- and remove bracket -2- with additional fuel pump.
  A20-10506
–  Open the spring strap clamps and remove the fuel hoses -2 and 4-.
Install
Installation is performed in the reverse order, pay attention to the following points:
  A20-10508
–  Tighten screws -3 and 4- to 20 Nm.
–  After replacing the additional fuel pump -V393-, fill up the fuel system → Chapter.
  A20-10506

Accelerator control > < Check voltage consumption of the fuel pump