Octavia Mk2
| Cylinder head cover - Summary of components |
| 1 - | Gasket |
| q | replace if damaged or leaking |
| 2 - | Cylinder head cover |
| q | removing and installing → Chapter |
| 3 - | O-ring |
| q | replace |
| 4 - | Hose |
| q | for crankcase ventilation |
| q | to remove, press release buttons |
| 5 - | Sealing bush |
| q | for fixing screw of fuel distributor |
| q | replace if damaged or leaking |
| 6 - | Support |
| q | for electrical cables |
| 7 - | Grommet |
| 8 - | Clamping claw |
| q | together with 2 injection units |
| 9 - | 8 Nm |
| 10 - | Fuel distributor |
| q | Observe rules for cleanliness → Chapter |
| q | Do not change the bending form of the high pressure pipes |
| q | Install high pressure lines → Chapter |
| 11 - | 22 Nm |
| 12 - | 8 Nm + torque a further 180° (1/2 turn) |
| q | replace |
| 13 - | Fuel return-flow line |
| 14 - | O-ring |
| q | replace |
| 15 - | Injection unit |
| q | Observe rules for cleanliness → Chapter |
| q | removing and installing → Chapter |
| 16 - | O-ring |
| q | replace |
| 17 - | Heat-protection seal |
| q | replace |
| 18 - | Sealing ring |
| q | for injection unit |
| q | replace → Chapter |
| 19 - | Screw cap |
| 20 - | Gasket |
| q | for cap |
| 21 - | Grommet |
| 22 - | Support |
| q | for electrical cables |
| 23 - | Screw, 10 Nm |
| q | Replace seal if damaged |
| q | tightening order and tightening torque → Fig. |
|
|
