Octavia Mk2
|
| 1 - | 15 Nm |
| 2 - | Sealing flange |
| q | on belt pulley side |
| q | must be positioned on dowel sleeves |
| q | removing and installing → Chapter |
| q | Replace crankshaft seal on belt pulley side → Chapter |
| 3 - | Toothed belt |
| q | for oil pump drive |
| q | check for wear and damage, replace if necessary. |
| q | mark the fitting position for re-installation |
| 4 - | 10 Nm |
| 5 - | Dipstick |
| q | Oil level must not exceed the max. marking |
| 6 - | Guide tube |
| 7 - | Retaining clip |
| 8 - | Fitting sleeve |
| 9 - | O-ring |
| q | replace |
| 10 - | 10 Nm |
| 11 - | Oil pump |
| q | with pressure control valve 0.45 MPa (4.5 bar) |
| q | with safety valve 1.0 MPa (10.0 bar) |
| q | removing and installing → Chapter |
| q | before installing, check whether both dowel sleeves are present |
| q | if there is any scoring on the contact surfaces of the gears, replace |
| q | Tighening torque of oil pump cover at oil pump housing: 10 Nm |
| If the toothed belt or the oil pump must be removed: |
| t | Check smooth operation of oil pump: |
| t | It must be possible to easily turn the toothed belt sprocket with the finger |
| t | if the oil pump is sluggish, it must be replaced → Chapter |
| 12 - | Intake manifold |
| q | Clean strainer if dirty |
| 13 - | Baffle |
| 14 - | 15 Nm |
| 15 - | 15 Nm |
| 16 - | Oil pan |
| q | removing and installing → Chapter |
| q | install with silicone sealant → Electronic catalogue of original parts |
| 17 - | 15 Nm |
| 18 - | Drain plug, 30 Nm |
| q | with integrated gasket ring |
| q | replace |
| 19 - | 10 Nm |
| q | replace |
| 20 - | Oil level and oil temperature sender -G266- |
| q | check → Vehicle diagnostic tester |
| q | removing and installing → Chapter |
| 21 - | O-ring |
| q | replace |
| 22 - | Line |
| q | to oil level and temperature sender |
| 23 - | Pressure valve, 27 Nm |
| q | opens at 0.25..0.32 MPa (2.5..3.2 bar) overpressure |
| q | replace without sealant |
| q | removing and installing → Chapter |
| 24 - | Oil injection nozzle |
| q | for piston cooling |
| q | removing and installing → Fig. |
