skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing oil pan > < Removing and installing the oil filter holder with the engine oil cooler

Octavia Mk2

Removing and installing engine oil cooler
Removing and installing engine oil cooler
Special tools and workshop equipment required
t  Catch pan, e.g. -VAS 6208-
t  Old oil collecting and suction equipment, e.g. -V.A.G 1782-
Removing
–  Drain coolant → Chapter.
–  Remove air filter → Chapter.
   
–  Remove oil filter insert -3-.
  N01-10738
–  Release screws -arrows-.
–  Remove engine oil cooler from oil filter holder.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
t  Replace all the gaskets and O-rings.
t  Hose connections as well as charge air pipes and charge air hoses must be free of oil and grease before being installed.
t  Observe the mounting sequence for hose connections with screw clamps → Chapter.
  N17-10204
–  Insert the new gasket -1- in the grooves at the oil filter holder.
–  Carefully position the engine oil cooler onto the dowel sleeves.
  N17-10205
–  Press in the engine oil cooler at the flange of the oil filter holder in such a way that it rests on the complete surface and the extremities of the dowel pins -1- protrude out of the openings of the guide.
  N17-10206
–  Insert screws -arrows-, first of all screw in by hand up to the stop, then gradually tighten crosswise.
   Tightening torque and tightening order → Anchor.
–  Install oil filter insert, fill with engine oil and check the oil level:
t  → BookletOctavia II
t  → BookletSuperb II
t  → BookletYeti
  Note
If the engine oil cooler was replaced, refill the entire system with coolant.
–  Top up with coolant, if necessary replace → Chapter.
  N17-10204

Removing and installing oil pan > < Removing and installing the oil filter holder with the engine oil cooler