skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing oil pressure switchF1 and oil pressure > < Removing and installing oil pump

Octavia Mk2

Removing and installing oil pressure switchF1
Removing and installing oil pressure switch -F1-
Removing
–  Remove engine cover → Chapter.
   
–  Remove the hose for the crankcase ventilation -1-, to do so press together the release buttons.
–  Expose vacuum hoses -arrows-.
–  Release hose clamp -3- and separate the intake hose from the air mass meter -G70-.
–  Release screw -2-, swivel intake hose with connection fitting towards the rear and detach from exhaust gas turbocharger.
  A21-10437
–  Unscrew screws -2- and -3- and remove engine lifting eye -1-.
–  Disconnect plug -arrow-.
–  Screw out oil pressure switch -F1-.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
Replace gasket ring.
Tightening torque: → Chapter
–  Install vacuum line.
  A17-10550

Testing oil pressure switchF1 and oil pressure > < Removing and installing oil pump