skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing crankshaft-belt pulley > < Removing and installing V-ribbed belt for vehicles without air conditioning system

Octavia Mk2

Removing and installing V-ribbed belt for vehicles with air conditioning system
Removing and installing V-ribbed belt for vehicles with air conditioning system
Special tools and workshop equipment required
t  Locking pin -T10060 A-
Removing
–  Remove the sound dampening system → Body Work; Rep. gr.50.
–  Remove the right wheelhouse liner (bottom part of the wheelhouse liner) → Body Work; Rep. gr.66.
  Caution
When installing, risk of damage through reversing the rotation direction of an already used V-ribbed belt.
If the V-ribbed belt is re-installed, mark the direction of rotation with chalk or a felt-tip pen before removing it.
   
–  Loosen the V-ribbed belt by swivelling the tensioning element in -the direction of the arrow-.
  N15-10398
–  Align the holes -arrows- and lock the tensioning element using the locking pin -T10060 A-.
–  Remove the V-ribbed belt.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
Before fitting the V-ribbed belt make sure that all assemblies (generator and AC compressor) are securely mounted.
  N13-10297
–  Lay the V-ribbed belt onto the V-ribbed belt pulleys.
1 - Crankshaft belt pulley with vibration damper
2 - Tensioning element
3 - AC generator
4 - AC compressor
  A13-10597
–  Hold the tensioning element with the ring spanner and pull out the locking pin -T10060 A-.
–  Release the tensioning element.
–  Check correct positioning of the V-ribbed belt.
–  Start engine and check ribbed V-belt run.
  N15-10398

Removing and installing crankshaft-belt pulley > < Removing and installing V-ribbed belt for vehicles without air conditioning system