Skoda Workshop Service and Repair Manuals

Removing and installing air filter Special tools and workshop equipment required t  Pliers for spring strap clamps Removing –  Remove engine cover → Chapter.

–  Remove cover for intake air duct, to do so release lateral securing tabs -arrows-.

–  Release screws -arrows- for connection fitting -1- and take connecting hose -2- out of the guide.

–  Press in catches -1- and -3- and pull off connecting hose -4- from air filter -2-.

–  Unplug connector -1- from air mass meter -G70-. –  Detach vacuum hose -3- and intake hose -2-. –  Release screw -4- and remove air filter with air mass meter -G70-. Remove intake hose   Note Due to the poor access of the pliers for spring strap clamps to the bottom intake hose it is preferable to remove the inlet connection from the exhaust gas turbocharger.

–  Unclip vacuum lines -2- and -3- from intake hose. –  Remove connecting pipe for crankcase ventilation -1-.

–  Fully release screw of inlet connection -2-. –  Swivel the inlet connection -3- in the -direction of the arrow A- and remove it with the intake hose -1-. Install Installation is performed in the reverse order, pay attention to the following points:   Note t  Replace O-ring. t  When installing the inlet connection -3- at the exhaust gas turbocharger, make sure that the inlet connection is correctly seated on the bolt -arrow B-.