Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Vehicle electrics | Electrical System | Lights, lamps, switches outside | Parking aid | Removing and installing the parking aid control unitJ446

Removing and installing the parking aid control unitJ446

Removing and installing the parking aid control unit -J446-

Removing

–	Switch off the ignition and all electrical components.

–	Remove left side luggage compartment trim panel → Body Work; Rep. gr.70.

–	Release and disconnect the plug connections.

–	Release nuts -arrows- (1.5 Nm) and take out parking aid control unit.

Install

–	Installation is performed in the reverse order, pay attention to the following points:

If the control unit for the parking aid -J446- is replaced:

–	Coding control unit → Vehicle diagnostic tester

Skoda Workshop Service and Repair Manuals