–
| Lever the sensor -1- carefully and slowly from the retaining plate -2- at the recess -3- using a suitable cross-head screwdriver. |
Note When removing, make sure to lever off the complete sensor and not only the upper shell of the sensor. |
Installation is performed in the reverse order, pay attention to the following points: |
Caution t
| Thoroughly clean the windscreen inside the retaining plate with e.g. isopropyl (technical alcohol). |
t
| The surface (coupling cushion) of the sensor must not get dirty or damaged when installing. A sensor with a damaged coupling cushion must be replaced. |
|
Note If the surface (coupling cushion) of the sensor is dirty, it can be cleaned, if necessary, by sticking on one or several adhesive tapes and then pulling them off again. |
–
| If necessary, remove the protective cap of the new sensor. |
|
|
|