skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing wiper motor from linkage > < Removing and installing the wiper arms with wiper blades and setting their final setting

Octavia Mk2

Removing and installing wiper motor with linkage
Removing and installing wiper motor with linkage
Removing
–  Switch off the ignition and all electrical components.
–  Remove wiper arms with wiper blades → Chapter.
–  Remove the cooling water tank cover → Body Work; Rep. gr.66.
   
–  Unplug connector -1- at wiper motor.
–  Release screws -arrows- (10 Nm).
–  Place wiring loom down to the side.
–  Removing wiper motor with linkage -2-.
Install
Installation is performed in the reverse order, pay attention to the following points:
  N92-10082
–  When installing the rig pin -2- correctly insert into rubber bearing -1- in the body.
  N92-10086

Removing and installing wiper motor from linkage > < Removing and installing the wiper arms with wiper blades and setting their final setting