Roomster
| Summary of components of engine bonnet release |
| 1 - | Rubber grommet |
| 2 - | Bowden cable |
| 3 - | Riveted nuts |
| 4 - | Console |
| 5 - | Release handle |
| Removing: |
| – | Unlock securing mechanism on the lever to the side. |
| – | Push out lever. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 6 - | Trim panel of pillar A below → Chapter |
| 7 - | 2.5 Nm |
| 8 - | Flap lock of engine bonnet |
| Removing: |
| – | Disconnect the plug connection (Pos. 10) from flap lock for engine bonnet |
| – | Detach Bowden wire (Pos. 2). |
| – | Remove fixing screws (Pos. 11) for flap lock. |
| – | Remove fixing screw (Pos. 12) for flap lock. |
| – | Slightly pull out the flap lock and unhook the control cable. |
| – | Remove flap lock for the engine bonnet. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 9 - | Clip |
| 10 - | Connector |
| 11 - | 20 Nm |
| 12 - | 9 Nm |