Removing and installing brake-power regulator |
Special tools and workshop equipment required |
t
| Brake-power regulator or brake system tester, e.g. -V.A.G 1310- or -V.A.G 1310 A- |
t
| Brake pedal arrester, e.g. -V.A.G 1238 B- or brake pedal load-V.A.G 1869/2- |
t
| Brake filling and bleeding device, e. g. -VAS 5234- |
t
| Catch pan (commercially available) |
t
| Repair kit SP-No. 1H0 698 311 A |
–
| Actuate brake pedal and arrest with brake pedal arrester. |
–
| Position the catch pan under the brake-power regulator to collect escaping brake fluid. |
–
| Mark brake lines (for re-installation). |
–
| Unscrew brake lines from brake-power regulator. |
–
| Shut-off brake lines to prevent brake fluid from running out and soiling. |
–
| Shut-off the connections of the brake lines on the brake-power regulator with screw plugs from repair kit SP No. 1 H0 698 311 A. |
–
| Screw out the oval-head countersunk screws → Item. |
–
| Remove brake-power regulator. |
WARNING Pay attention to the correct channel assignment of the brake lines. Interchanging the brake lines will result in dangerous brake control actions. |
|
Installation is carried out in the reverse order. |
|
|
|