Skoda Workshop Service and Repair Manuals > Roomster > Chassis | Steering

Removing and installing steering lock

Special tools and workshop equipment required

t	Vehicle diagnosis, measurement and information system -VAS-

Note

Pay attention to the measures after re-connecting the battery → Electrical System; Rep. gr.27.

Remove steering lock:

–	Disconnect battery → Electrical System; Rep. gr.27.

–	Remove steering wheel with airbag → Body Work; Rep. gr.69.

–	Remove dash panel protective label with top steering column trim panel → Body Work; Rep. gr.69.

–	Remove bottom steering column trim panel → Body work; Rep. gr.69.

–	Removing steering-column control → Electrical System; Rep. gr.94.

–	Unplug connector for the ignition starter switch -1- and the connector for the immobilizer -2- reading coil.

–	Removing lock cylinder and ignition starter switch → Electrical System; Rep. gr.94.

–	Remove pull-off screws -arrows- (bore out).

–	Take out steering lock.

Install steering lock:

–	Insert the steering lock and tighten with new pull-off screws.

–	Tighten pull-off screws until the screw head shears off.

–	Installing lock cylinder and ignition starter switch → Electrical System; Rep. gr.94.

–	Unplug connector for the ignition starter switch -1- and connect the connector for the immobilizer -2- reading coil.

–	Install the steering-column control → Electrical System; Rep. gr.94.

–	Install bottom steering column trim panel → Body Work; Rep. gr.70.

–	Install dash panel protective label with top steering column trim panel → Body Work; Rep. gr.70.

–	Install the steering wheel with airbag → Body Work; Rep. gr.69.

Note

Pay attention to the measures after re-connecting the battery → Electrical System; Rep. gr.27.

–	Connect battery → Electrical System; Rep. gr.27.

–	Interrogate fault memory or eliminate fault → Vehicle diagnostic tester.

Skoda Workshop Service and Repair Manuals