skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing gearbox (Fabia II, Roomster) > < Shift mechanism

Roomster

Removing and installing gearbox (Fabia II, Roomster)
Removing and installing gearbox (Fabia II, Roomster)
Special tools and workshop equipment required
t  Removal tool for the inner lining of the door panel-MP8-602/1-
t  Supporting device -MP9-200 (10-222A)-
t  Adapter -MP9-200/3 (10-222A/3)-
t  Adapter -MP9-200/18 (10-222A/18)-
t  Gearbox mount -3282-
t  Bolt -3282/29-
t  Adjusting plate -3282/59-
t  Tensioning strap -T10038-
t  Engine/gearbox jack, e.g. -V.A.G 1383 A-
t  Socket insert, e.g. -T10035- or socket insert XZN 14 -T10061-
Remove gearbox (Fabia II, Roomster) → Chapter.
Install gearbox (Fabia II, Roomster) → Chapter.
Tightening torques (Fabia II, Roomster) → Chapter.
  Note
t  Observe instructions for automatic gearbox DSG - 0AM → Chapter.
t  General repair information → Chapter.
t  All cable straps which are detached or cut open when removing, should be fitted on again in the same place when installing.
t  If the battery earth strap is disconnected and connected, carry out additional operations → Electrical System; Rep. gr.27.
   

Removing and installing gearbox (Fabia II, Roomster) > < Shift mechanism