skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Enginecrankshaft group, pistons > < Self diagnosis, safety measures, cleanliness regulations, directions

Roomster

Tightening torques
Tightening torques
   
Assembly bracket - engine, version 1
1 - 20 Nm + torque a further 90° (1/4 turn) - replace
2 - 30 Nm + torque a further 90° (1/4 turn) - replace
  S10-0382
Assembly bracket - engine, version 2
1 - 20 Nm + torque a further 90° (1/4 turn) - replace
2 - 30 Nm + torque a further 90° (1/4 turn) - replace
3 - 16 Nm
  S10-0452
Assembly bracket - gearbox
  Note
Tighten screws -1- in the following sequence: rear, front and then upwards.
1 - 50 Nm + torque a further 90° (1/4 turn) - replace
2 - 40 Nm + torque a further 90° (1/4 turn) - replace
  S10-0125
Pendulum support
  Note
Before tightening the screws -1- press off gearbox in the elongated holes of the pendulum support to the front in such a way that there is maximum distance between the gearbox and the assembly carrier.
1 - 30 Nm + torque a further 90° (1/4 turn) - replace
2 - 40 Nm + torque a further 90° (1/4 turn) - replace
  S10-0126

Enginecrankshaft group, pistons > < Self diagnosis, safety measures, cleanliness regulations, directions