Superb
| V-ribbed belt - Summary of components |
| 1 - | 25 Nm |
| 2 - | Tensioner for V-ribbed belt |
| q | swivel tensioning device for V-ribbed belt with open-end wrench to slacken the V-ribbed belt → Chapter |
| 3 - | Timing belt guard - middle part |
| 4 - | Timing belt guard - top part |
| 5 - | Washer |
| 6 - | Tensioning pulley |
| q | Tensioning toothed belt → Anchor |
| q | inspect semi-automatic tensioning pulley → Chapter |
| 7 - | 20 Nm |
| 8 - | Timing belt |
| q | before removing mark running direction |
| q | check for wear |
| q | do not kink |
| q | removing and installing, tensioning → Chapter |
| 9 - | 20 Nm |
| 10 - | Rear timing belt guard |
| 11 - | O-ring |
| q | replace |
| 12 - | Coolant pump |
| 13 - | 15 Nm |
| 14 - | Crankshaft toothed belt sprocket |
| 15 - | 90 Nm + torque a further 1/4 turn (90°) |
| q | replace |
| q | thread and collar must be free of oil and grease. |
| q | to release and tighten the counterholder -T 30004- or -MP 1-310- use |
| q | when bolting on counter-holder -MP 1-310-, place 2 washers between timing belt sprocket and counter-holder |
| 16 - | Timing belt guard - bottom part |
| 17 - | 10 Nm |
| 18 - | Belt pulley |
| q | for the visco fan coupling |
| 19 - | Belt pulley |
| q | for the vane pump on the power-assisted steering |
| 20 - | 25 Nm |
| 21 - | V-ribbed belt |
| q | before removing mark running direction |
| q | check for wear |
| q | removing and installing → Chapter |
| 22 - | Vibration damper/belt pulley |
| q | assembly only possible in one position -holes offset- |
| q | take note of the position when installing the timing belt → Chapter |
