| –
| Remove base paper from self-adhesive foils -1-. |
| –
| Stick self-adhesive foils -1- onto the front and rear doors, pay attention to the following points: |
| Dimension -a- = 30 mm (from the top side of the door -2-) |
| Dimension -b- = 90 mm (joint between front and rear door) |
| –
| Wrap projecting foil parts -1- around the door edges. |
| –
| If necessary smoothen the foils (e.g. with rubber cylinder). |
| The process for the right doors is identical. |
Note | Do not drive into the carwash within 24 hours after sticking on the foils. |
| –
| Heat the foils which must be removed with hot-air blower, e.g. -V.A.G 1416-, at an air temperature of max. 100°C. |
| –
| Remove foils in a sharp angle through extensive pulling. |
| –
| Clean vehicle surface with technical petrol. |
|
|
|
