| Removing and installing the locking button for locking rod |
| The locking knobs must be removed and installed as described below. |
| Failing to comply with these instructions may cause the locking rods to loosen or the support may become damaged. |
| –
| Turn the locking button 180° to the left. |
| –
| Remove the locking button from the top. |
| –
| Position the locking button with the marking (dot on top side) on the locking rod. |
| –
| Press the locking button down onto the locking rod until the spline is at the level of the door trim panel. |
| –
| Subsequently, turn the locking button 180° to the left. |
|
|
|
