Superb
Disassembling and assembling oil filter holder |
1 - | Oil pressure switch - F1- - 20 Nm |
q | 0.07 MPa (0.7 bar) switch |
q | Cut open gasket ring if leaking and replace |
q | check → Chapter |
2 - | Gasket |
q | replace |
3 - | 15 Nm + torque a further 90° (1/4 turn) |
q | replace |
q | first of all set up the bolt at the top left and the bottom right and then tighten all four bolts cross-wise |
4 - | Oil filter holder |
q | with oil retaining valve |
q | the oil retaining valve cannot be replaced individually |
5 - | Gasket ring |
q | replace |
6 - | Oil feed line |
q | to exhaust turbocharger |
7 - | Hollow screw - 25 Nm |
8 - | Cap - 25 Nm |
q | release and tighten with wrench for oil filter - 3417- |
9 - | O-ring |
q | replace |
10 - | Oil filter element |
q | check fitting position: Marking “TOP” faces up |
q | pay attention to change intervals |
11 - | Oil cooler |
q | ensure clearance to surrounding components |
q | Pay attention to the information regarding a necessary replacement. |
q | connection diagram for coolant hoses → Chapter |
12 - | Screw plug - 25 Nm |
13 - | Gasket |
q | replace |
14 - | Gasket |
q | replace |
q | fit into the grooves on the oil cooler |
15 - | Screw plug - 10 Nm |
q | Cut open gasket ring if leaking and replace |
16 - | Screw plug |
q | for oil retaining valve |
q | do not slacken |