skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Removing and installing parts of the lubrication system

Superb

Removing and installing coolant pump
Removing and installing coolant pump
Removing
–  Put lock carrier in service position → Body Work; Rep. Gr.50.
–  Drain coolant → Chapter.
–  Removing toothed belt → Chapter.
–  Remove the front intake manifold.
   
–  Pull out the timing belt guard at the rear in the middle -2- upwards.
–  Screw out the screws -right arrows- and remove the timing belt guard at the rear on the left -3-.
  S15-0365
–  Unscrew fixing screws -arrows- of the coolant pump and remove the coolant pump.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
Always replace seals and gasket rings.
–  install (set the timing) → Chapter.
–  Top up coolant → Chapter.
  S19-0195

Fuel supply, gas operation > < Removing and installing parts of the lubrication system