skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Wear assessment of the gearbox components > < Replacing Speedometer sender G22

Superb

Removing and installing Speedometer senderG22
Removing and installing Speedometer sender -G22-
Removing
–  Remove front wheel on the left.
   
–  Remove left drive shaft noise insulation from wheel arch -arrows-.
–  Remove shield/left drive shaft.
  S37-0158
–  Unplug connector -arrow A- from speedometer sender -G22-.
–  Press down the retaining clip of the speedometer sender -G22- and turn -direction of arrow-.
–  Pull out the speedometer sender -G22-.
Install
Installation is carried out in the reverse order. Pay attention to the following:
  S37-0171
–  Replace O-rings -arrows- → Electronic Catalogue of Original Parts.
–  Insert new O-rings applying axle oil.
–  Insert the speedometer sender -G22-.
–  Engage the retaining clip in the mounting for the flange shaft.
–  Attach the shield/left drive shaft → Running gear; Rep. Gr.40.
–  Fit the left front wheel → Running gear; Rep. Gr.40.
  A38-0017

Wear assessment of the gearbox components > < Replacing Speedometer sender G22