Superb
|
|
Position | Screw | Qty | Nm |
1 | M12 x 67 | 2 | 65 |
2 | M12 x 80 1) | 1 | 65 |
3 | M12 x 90 2) | 1 | 65 |
4 | M12 x 75 | 1 | 65 |
5 | M10 x 50 3) | 1 | 45 |
6 | M10 x 45 | 3 | 45 |
7 | M10 x 110 4) | 1 | 65 |
8 | M12 x 110 4) | 1 | 65 |
A | Dowel sleeves for centering | 2 |
1) with strut for exhaust turbocharger | |
2) with bracket for wiring | |
3) with screw and nut (hammer head bolt) | |
4) Starter to gearbox |
|
Position | Screw | Qty | Nm |
1 | M12 x 75 | 1 | 65 |
2 | M12 x 110 1) | 2 | 65 |
3 | M12 x 90 | 1 | 65 |
4 | M10 x 50 | 1 | 45 |
5 | M10 x 45 | 3 | 45 |
6 | M12 x 75 2) | 1 | 65 |
7 | M12 x 90 2) | 1 | 65 |
8 | M12 x 65 1) | 1 | 65 |
A | Dowel sleeves for centering | 2 |
1) with bracket for wiring | |
2) Starter to gearbox |
|
Pos. | Screw | Nm |
1 | M10 x 35 | 50 |
2 | M10 x 30 | 40 |
31) | M8 x 22 | 27 |
1) Always replace screws → Electronic Catalogue of Original Parts |
|
Pos. | Screw | Nm |
1 | M10 x 35 | 50 |
2 | M10 x 30 | 40 |
31) | M8 x 22 | 27 |
1) Always replace screws → Electronic Catalogue of Original Parts |
Tightening torques |
Component | Nm |
Slave cylinder to gearbox 1) | → Chapter |
Engine speed sender - G28- on the gearbox | 10 |
Shield/drive shaft to gearbox | 25 |
Push rod to gearbox | → Chapter |
Shift rod/gearbox shift lever to gearbox 2) | → Chapter |
Link rod to gearbox | → Chapter |
Shield to left gearbox support bracket | 10 |
Front exhaust pipe to turbocharger | 25 |
Clamping sleeve for the exhaust pipe | 40 |
Bracket for front exhaust pipe to gearbox | 25 |
Noise insulation panel bracket to assembly carrier | 10 |
1) Always replace screw → Electronic Catalogue of Original Parts. |
2) Always replace nut → Electronic Catalogue of Original Parts. |