skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Hauptbremszylinder > < Vacuum sensor G608 (vehicles with four-wheel-drive and left-hand drive)

Yeti

Removing and installing the piston for the brake caliper (CI 38)
Removing and installing the piston for the brake caliper (CI 38)
Special tools and workshop equipment required
t  Resetting tool -T10165-
t  Disassembly wedge -3409-
Removing:
   
Insert the resetting tool -T10165- in such a way that the collar is resting on the piston.
–  Release the piston by turning the knurled wheel of the resetting tool -T10165- to the left.
t  Use open-jawed spanner on a provided spanner surface -arrow A- if the piston is difficult to move.
  S47-0089
–  Remove gasket ring with disassembly wedge -3409-.
Installing:
–  Clean piston and gasket ring with white spirits and dry off.
–  Before installing the piston and gasket ring thinly coat with lithium grease -G 052 150 A2-.
  S47-0036
–  Position the new protective cap with the outer sealing lip on the piston.
–  Insert the inner sealing lip of the collar into the groove of the cylinder using the disassembly wedge -3409-.
  S47-0032
To do so hold the piston in front of the brake caliper.
  Caution
Use the resetting tool -T10165- to adjust the piston.
The automatic adjustment in the brake caliper is destroyed when adjusting the piston with a resetting tool e.g. -T10165- or by actuating the brake pedal.
  S47-0038
Insert the resetting tool -T10165- in such a way that the collar is resting on the brake caliper.
–  Screw the piston by turning the knurled wheel of the resetting tool -T10165- to the right into the brake caliper.
  S47-0090

Hauptbremszylinder > < Vacuum sensor G608 (vehicles with four-wheel-drive and left-hand drive)