Yeti
| Summary of components - vehicles with four-wheel drive |
| 1 - | Bushing |
| q | for selector rods |
| q | removing → Fig. |
| q | inserting → Fig. |
| 2 - | Shaft for reverse gear shift fork |
| q | Shaft cannot be removed with workshop tools |
| q | when using a new clutch housing a new axle must be pressed in → Fig. |
| q | Modification as of 06.09: on gearboxes where the reverse gear shift fork is positioned on the 5th/6th gear shift rod, the shaft is not fitted |
| 3 - | Needle bushing |
| q | for reverse shaft |
| q | replace after each disassembly → electronic catalogue of original parts |
| q | removing → Fig. |
| q | installing → Fig. |
| 4 - | Fitting sleeve |
| q | 2 pieces |
| 5 - | Clutch housing |
| q | when replacing: Set the output shafts and the differential gear → Chapter |
| q | Modification as of 06.09: on gearboxes where the reverse gear shift fork is positioned on the 5th/6th gear shift rod, the shaft for reverse gear shift fork is not fitted |
| q | assign according to the → Electronic catalogue of original parts. |
| 6 - | Gasket ring for drive shaft |
| q | removing → Fig. |
| q | inserting → Fig. |
| 7 - | Sealing ring |
| q | between manual gearbox and angle gearbox |
| q | replace with installed gearbox → Chapter |
| q | pull out using ejection lever -MP3-418- or extraction hook -T20143- |
| q | on disassembled gearbox it can be driven in with pressure plate -T40007- up to the stop |
| 8 - | Washer |
| q | for differential gear |
| q | Fitting position: the shoulder on the inside diameter points towards the gasket ring Pos. 7 |
| 9 - | Outer ring/tapered-roller bearing |
| q | for the differential gear |
| q | removing and installing → Chapter |
| q | when replacing: Set the differential gear → Chapter |
| 10 - | Oil deflecting washer |
| q | Fitting position: The shoulder on the hole points to the output shaft |
| 11 - | Outer ring/tapered-roller bearing |
| q | for output shaft gears 1 through 4 |
| q | removing and installing → Chapter |
| q | when replacing: Set output shaft gears 1 through 4 → Chapter |
| 12 - | Outer ring/tapered-roller bearing |
| q | for output shaft 5th/6th and reverse gear |
| q | removing and installing → Chapter |
| q | when replacing: Set output shaft 5th/6th and reverse gear → Chapter |
| 13 - | Washer |
| q | for output shaft 5th/6th and reverse gear |
| q | always 0.65 mm thick |
| 14 - | Cylindrical-roller bearing |
| q | for drive shaft |
| q | removing and installing → Chapter |
| 15 - | Magnet |
| q | is held in position by the separator surface of the housing |
| 16 - | Cap |
| q | not fitted to all clutch housings |