Skoda Yeti Manual Gearbox Differential Gear Adjustment

Determine the adjusting washer

The prescribed bearing preload is reached by adding to the established measured value (example: 1.50°mm) a constant compression value (0.25 mm).

Example

measured value		1.50 mm
+ pressure (const. value)		0.25 mm
Thickness of the adjusting washer	=	1.75 mm

–	Remove the clutch housing and press out the outer ring/tapered-roller bearing -A-.

-B-Interior extractor 46 ... 58 mm, e.g. -Kukko 21/7-

–	Position pipe -2040 (T30041)- directly on the feet of the interior extractor-B- and press out the outer ring/tapered-roller bearing -A-.

Note

Available adjusting washers

Adjusting washer thickness (mm)
0,65	0,90	1,15
0,70	0,95	1,20
0,75	1,00	1,25
0,80	1,05
0,85	1,10

Different tolerances allow to select the required thickness for each washer very precisely.

If the measured washer thickness is greater than the one listed in the table, 2 washers corresponding to the measured value may be fitted.

–	Insert adjusting washer with the required thickness (in this example 1.75 mm) and press the outer ring/tapered-roller bearing back into the clutch housing.

–	Position the clutch housing and tighten the screws to the given tightening torque → Chapter.

Skoda Yeti Repair Manuals & Workshop Service