skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing components > < Removing and installing the high pressure pump

Yeti

Removing and installing intake manifold
Removing and installing intake manifold
Special tools and workshop equipment required
t  Pliers for spring strap clamps
Removing
  Note
t  Safety precautions when working on the fuel supply system → Chapter.
t  Rules of cleanliness when working on the fuel supply system → Chapter.
–  Switch off the ignition and all electrical components and take out the ignition key.
–  Drain the coolant from the charge air cooling system → Chapter.
–  Remove the throttle valve control unit → Chapter.
   
–  Disconnect the feed line -2- (press in the securing ring to the top) and catch the fuel which flows out with a cleaning cloth.
  S10-0213
–  Remove the coolant hoses -1- and disconnect the plug connections -2-.
–  Remove the fuel feed line -3- and unscrew the fixing screws -4- of the intake manifold.
Install
Installation occurs in reverse order to removal.
t  Tightening torque of fixing screws for intake manifold: 20 Nm
t  Tightening torque and tightening sequence for charge-air cooler: → Chapter
–  Top up and bleed cooling system → Chapter.
  N21-10188

Testing components > < Removing and installing the high pressure pump