Yeti
Removing and installing parts of the lubrication system - Summary of components |
1 - | 15 Nm |
2 - | Sealing flange on the belt pulley side |
q | must be positioned on dowel sleeves |
q | removing and installing → Chapter |
q | Replace crankshaft seal on belt pulley side → Chapter |
3 - | Toothed belt for oil pump |
q | check for wear and damage, replace if necessary. |
4 - | 10 Nm |
5 - | Dipstick |
q | oil level must not exceed max. marking |
6 - | Guide tube |
7 - | Clip |
8 - | Dowel sleeves |
9 - | O-ring |
q | replace |
10 - | 10 Nm |
11 - | Oil pump |
q | before installing, check whether both dowel sleeves are present |
q | if there is any scoring on the contact surfaces of the gears, replace |
q | Tighening torque of oil pump cover at oil pump housing: 10 Nm |
12 - | Intake manifold |
q | Clean strainer if dirty |
13 - | Baffle |
14 - | 15 Nm |
15 - | 13 Nm |
16 - | Oil pan |
q | removing and installing: |
t | Fabia II, Roomster, Rapid → Chapter |
t | Octavia II, Superb II, Yeti → Chapter |
q | install with silicone sealant -D 176 404 A2- |
17 - | 16 Nm |
18 - | Drain plug, 30 Nm |
q | with integrated gasket ring |
q | replace |
19 - | 10 Nm |
q | replace |
20 - | Oil level and oil temperature sender -G266- |
q | check → Vehicle diagnostic tester |
21 - | O-ring |
q | replace |
22 - | Wiring loom to oil level and oil temperature sender |
23 - | Pressure relief valve, 27 Nm |
q | opens at 0.25..0.32 MPa (2.5..3.2 bar) overpressure |
q | replace without sealant |
q | removing and installing → Fig. |
24 - | Oil injection nozzle |
q | for piston cooling |
q | removing and installing → Fig. |