skoda Workshop Repair Guides

Skoda Yeti Workshop Service & Repair Manuals | Auto Books

ABOUT US
Aligning exhaust system free of stress > < Removing and installing pre-exhaust pipe with diesel particle filter

Replacing Middle or Rear Part of Exhaust System

Replacing middle or rear part of the exhaust system
Replacing middle or rear part of the exhaust system
(Octavia II, Superb II, Yeti)
Special tools and workshop equipment required
t  Body saw e.g. -V.A.G 1523 A-
t  Protective goggles
Work procedure
  Note
t  For individually replacing the middle or rear part of the exhaust system, a separation point is provided in the connecting pipe.
t  The separation point is marked by indentations on the circumference of the exhaust pipe.
  WARNING
In order to avoid injuries because of metal swarfs, wear safety goggles and safety clothing.
   
–  Separate exhaust pipe at right angles at the separation point -arrow 2-.
–  When installing, position warm-type clamp -4- at the side markings -arrow 1- and -arrow 3-.
–  Turn the warm-type clamp -4- in such a way that the ends of the screws are as far upwards as possible.
–  Align rear part of exhaust system horizontally and tighten warm-type clamp to 23 Nm.
–  Align exhaust system free of stress:
t  Octavia II → Chapter.
t  Superb II, Yeti → Chapter.
  S26-0147

Aligning exhaust system free of stress > < Removing and installing pre-exhaust pipe with diesel particle filter