Skoda Workshop Service and Repair Manuals > Yeti > Vehicle electrics | Electrical System | Windscreen wipe/wash system | Windscreen washer system | Remove and install reservoir, pumps and sensor for washer fluid level

Remove and install reservoir, pumps and sensor for washer fluid level

Removing

Note

t	Depending on the version, the positions of the individual components and the hose connection can differ from the version in the illustrations. The assembly work can be carried out in a similar way.

t	For vehicles with auxiliary heating, there is a different arrangement of the pumps and the sensors at the reservoir, however their separation procedure is identical.

–	Switch off the ignition and all electrical components.

–	Remove front bumper → Body Work; Rep. gr.63.

–	Release plug from the washer fluid pumps for windscreen -2-, for headlight -10- and from sensor for washer fluid level -6-.

–	To unlock, pull out the locking clip on the hose connections -5- (black marking - front windscreen washer) and -3- (white marking - rear windscreen washer) and disconnect the connections from the washer fluid pump -4-. Collect the flowing out washer fluid in a suitable vessel.

–	Release washer hose for headlight -8- by pressing the locking clip and detach.

–	If necessary pull the washer fluid pumps -9- and -4- out of the reservoir to the top as well as the sensor for washer fluid level -7- out of the rubber bearing.

–	Expose wiring loom.

–	Loosen pipe -3- for activated charcoal filter system or pipe for auxiliary heating from filler neck -2- of windshield washer reservoir.

–	Release screw -1- (8 Nm).

–	Remove headlight → Chapter.

Vehicles without auxiliary heating system

–	Screw out screws and nuts -arrows- (8 Nm) and remove windshield washer fluid reservoir downwards.

Vehicles fitted with auxiliary heating

–	Unscrew the front fixing screws -arrows from the side- (8 Nm) and the rear fixing screw -arrow from the top- (5 Nm).

–	Push the reservoir slightly forwards, during this procedure slacken it from the bearing in the bracket and remove it to the bottom.

Install

Installation is performed in the reverse order, pay attention to the following points:

–	Vehicles fitted with auxiliary heating- observe the correct seating of the guides in the recesses in the holder of the reservoir.

–	Hoses with angled pieces must click audibly into the connections on the washer fluid pumps.

–	After completing the assembly work bleed the headlamp cleaning system. → Chapter.

Skoda Workshop Service and Repair Manuals