Tribeca F6-3.6L (2008)
NOTE: If it is hard to remove, use the ST.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER PLATE
INSTALLATION
1. Aligning the hub unit bearing to the mounting hole of the back plate, install the hub unit assembly and back plate. Tighten the axle nut temporarily.
CAUTION:
^
Be careful not to damage the magnetic encoder.
^
Do not get closer the tool which charged magnetism to magnetic encoder.
2. Tighten the four bolts to the back plate.
Tightening torque: 65 Nm (6.6 kgf-m, 47.9 ft. lbs.)
