Tribeca F6-3.6L (2008)
3. Remove the axle nut.
4. Draw the rear drive shaft into specified position.
5. Tighten the new axle nut temporarily.
CAUTION: Use a new axle nut (olive color).
6. Install the disc rotor to hub.
7. Install the disc brake caliper on the rear housing.
Tightening torque: 60 Nm (6.1 kgf-m, 44.3 ft. lbs.)
8. Adjust the parking brake lever stroke by turning the adjuster.
9. While applying the parking brake and depressing the brake pedal, tighten a new axle nut (olive color) to the specified torque and lock it securely.
Tightening torque: 240 Nm (24.5 kgf-m, 177 ft. lbs.)
CAUTION:
^
Install the wheel after installation of axle nut. Failure to follow this rule may damage the wheel bearing.
^
Be sure to tighten the axle nut to specified torque. Do not overtighten it as this may damage the wheel bearing.
10. After tightening the axle nut, lock it securely.
11. Install the wheel and tighten the wheel nuts to specified torque.
Tightening torque: 110 Nm (11.2 kgf-m, 81.1 ft. lbs.)
DISASSEMBLY
Using the ST and a hydraulic press, push out the hub bolts.
ST 28399AG000 HUB STAND
