Tribeca F6-3.6L (2008)
CAUTION:
^
Be careful not to hammer the hub bolts. This may deform the hub.
^
Do not reuse the hub bolt.
NOTE: Since the hub unit bearing can not be disassembled, only hub bolts can be removed.
ASSEMBLY
1. Attach the hub to the ST securely.
ST2 8099PA080 HUB STAND
2. Using a press, press the new hub bolts until their seating surfaces contact the hub.
NOTE: Use the 12 mm (0.47 inch) dia. holes in the HUB STAND to prevent bolts from tilting.
INSPECTION
1. Moving the rear tire up and down by hand, check there is no backlash in bearing, and check the wheel rotates smoothly.
2. Inspect the lean of axis direction using a dial gauge. Replace the hub bearing if the play exceeds the limit value.
Service limit: Maximum: 0.05 mm (0.0020 inch)
