Alignment: Specifications (page 3 of 9)
- Make
- Subaru
- Model
- Tribeca F6-
- Engine
- 3.6L
- Year
- 2008
- Section
- Alignment
Steering and SuspensionSpecifications · page 3 of 9
2. CAMBER
^
INSPECTION
1. Place the front wheel on the turning radius gauge. Make sure the ground contact surfaces of front and rear wheels are at the same height.
2. Set the adapter at the center of wheel, and then attach the wheel alignment gauge.
3. Measure the camber angle in accordance with the operation manual for wheel alignment gauge.
^
FRONT CAMBER ADJUSTMENT
1. When adjusting the camber, adjust it to the following value.
Pinch or Ctrl + scroll to zoom. Double-tap to reset.
The same page in: Tribeca F6-3.6L (2008).
Parts & tools for this job For 2008 Subaru Tribeca 3.6L
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Subaru power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.