XT-6 2WD L6-2.7L SOHC (1989)
Technical Service Bulletin # 040791
Date: 911223
MPS Controller Set - Installation Instructions
NUMBER:
04-07-91
DATE:
12-23-91
APPLICABILITY XT6 VEHICLES
SUBJECT:
INSTALLATION INSTRUCTIONS FOR MPS CONTROLLER SET
An MPS Controller Set, P/N 31186GA070 is now available and includes the following parts.
Power Controller
31186GA000
Modified Signal Controller Assembly
31186GA050
(Includes Harness "A" & "B")
Clip, Quantity 4
94070GA010
The MPS Controller Set offers reliability refinements as well as improved diagnosis through the addition of a memory function.
For additional, general troubleshooting information refer to Subaru Service Bulletin Number 04-06-91, Dated 09-11-91 and the applicable Subaru
Service Manual.
Installation of Signal Controller and Harness "A"
1.
Disconnect negative battery cable.
2.
The signal controller is located inside the vehicle, behind the left side rear seat armrest trim panel mounted next to the automatic seat belt rail
motor. Remove trim from this area as described in the applicable service manual to gain access. See Figure 1.