Grand Vitara 2WD V6-2.7L (2006)
Removal
1. Hoist vehicle and remove rear wheels.
2. Remove control rod.
3. Remove trailing rod.
4. Remove lower arm.
5. Remove rear suspension knuckle.
6. Remove wheel sensor bolts (1) from upper arm (2).
7. Remove upper arm bolts (1) and then upper arm (2).
Installation
1. Install upper arm.
a. Install upper arm (2) to rear suspension frame.
b. Insert upper arm bolt (1) from the upper arm inside.
c. Tighten upper arm mount nuts (3) temporarily by hand.
CAUTION: If reuse upper arm mount nut, apply engine oil to thread and bearing.