XL-7 2WD V6-3.6L (2007)
the commanded states.
^
If the test lamp is always ON, test the supply voltage circuit for a short to voltage. If the circuit tests normal, replace the BCM.
^
If the test lamp is always OFF, test the supply voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal,
replace the BCM.
7. If all circuits test normal, test or replace the appropriate turn signal lamp assembly.
Repair Instructions
Perform the [Diagnostic Repair Verification - Vehicle Diagnostic Information] after completing the diagnostic procedure. See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures
^
[Turn Signal Multifunction Switch Replacement]
^
[Control Module References] for BCM, IPC, and door control module replacement, setup, and programming See: Testing and
Inspection/Programming and Relearning