XL-7 2WD V6-3.6L (2007)
CAUTION:
Refer to [Fastener Notice].
NOTE:
Hand tighten the power steering gear inlet hose fittings before finalizing the torques.
2. Connect the power steering gear inlet hose fitting (1) to the steering gear.
Tightening torque
Tighten the fitting to 25 Nm (18 ft. lbs.).
3. Connect the power steering gear inlet hose fitting (1) to the power steering pump.
Tightening torque
Tighten the fitting to 25 Nm (18 ft. lbs.).
4. Than any excess fluid from the vehicle and remove the drain pans.
5. Install the front tire wheel assemblies.
6. Fill and bleed the power steering system.