XL-7 2WD V6-3.6L (2007)
NOTE:
^
Some lock ring were manufactured with DO NOT REUSE stamped into them. These lock rings may be reused if they are not damaged or
warped.
^
Inspect the lock ring for damage due to improper removal or installation procedures. If damage is found, install a NEW lock ring.
^
Check the lock ring for flatness.
8. Place the lock ring on a flat surface. Measure the clearance between to lock ring and the flat surface using a feeler gage at 7 points.
9. If the warpage is less than 0.41 mm (0.016 in), the lock ring does not require replacement.
10. If the warpage is greater than 0.41 mm (0.016 in), the lock ring must be replaced.
Installation Procedure
1. If the fuel level sending unit is being replaced, install the fuel level sending unit onto the new fuel pump. Refer to Primary Fuel Level Sensor
Replacement.