XL-7 2WD V6-3.6L (2007)
NOTE:
Ensure that the J 45201 is fully seated into the transaxle seal bore.
5. Insert the collet piece (2) of the J 45201 into the cooler line seal.
6. Insert the forcing screw piece (1) of the J 45201 into the collet (2).
7. Tighten the forcing screw (1) until snug.
8. Thread the collar piece (1) of the J 45201 onto the collet (3) until snug.
9. Turn the collar clockwise in order to remove the cooler line seal (87).
10. Discard the seal (87).
11. Clean the case bores for the cooler line seals.
Installation Procedure
1. Insert a new transaxle cooler line seal into the case bore.