Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
![background image](/toyota/camry/l4-2.4l_(2az-fxe)_hybrid/Page-2352012.png)
(a) Raise the rear suspension member with a jack.
(b) Install the rear suspension member with the 2 bolts.
Torque: 56 Nm (571 kgf-cm, 41ft-lbf)
3. INSTALL REAR SUSPENSION MEMBER LOWER STOPPER LH
(a) Install the rear suspension member lower stopper LH with the 2 nuts.
Nut A - Torque: 55 Nm (561 kgf-cm, 41ft-lbf)
Nut B - Torque: 38 Nm (388 kgf-cm, 28ft-lbf)
4. INSTALL REAR SUSPENSION MEMBER LOWER STOPPER RH
(a) Install the rear suspension member lower stopper RH with the 2 nuts.
Nut A - Torque: 55 Nm (561 kgf-cm, 41ft-lbf)
Nut B - Torque: 38 Nm (388 kgf-cm, 28ft-lbf)
5. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM LH
(a) Connect the rear No.1 suspension arm (outer side) to the rear axle carrier with the bolt and nut and temporarily tighten the bolt and nut.
NOTICE: When temporarily tightening the bolt, keep the nut from rotating.
HINT: Insert the bolt from the front of the vehicle and temporarily install the bolt.
6. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM RH
HINT: Temporarily tighten the RH side using the same procedures as for the LH side.
7. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM LH