Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
(a) Connect the rear No. 2 suspension arm (outer side) to the rear axle carrier with the bolt and nut and temporarily tighten the bolt.
NOTICE: When temporarily tightening the bolt, keep the nut from rotating.
HINT: Insert the bolt from the rear of the vehicle and temporarily install the bolt.
8. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM RH
HINT: Temporarily tighten the RH side using the same procedures as for the LH side.
9. TEMPORARILY TIGHTEN REAR STRUT ROD
(a) Connect the rear strut rod assembly to the axle carrier with the bolt and nut and temporarily tighten the bolt.
NOTICE: When temporarily tightening the bolt, keep the nut from rotating.
HINT: Insert the bolt from the inside of the vehicle and temporarily install the bolt.
10. STABILIZE SUSPENSION See: Trailing Arm/Service and Repair/Installation
11. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM LH
(a) Fully tighten the bolt.
Torque: 100 Nm (1,020 kgf-cm, 74ft-lbf)
12. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM RH
HINT: Fully tighten the RH side using the same procedures as for the LH side.
13. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM LH