Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
![background image](/toyota/camry_ce_sedan_4-door/l4-2164cc_2.2l_dohc_mfi/Page-1835001.png)
Alignment: Service and Repair
Rear
1. Measure vehicle height.
Tire size: 195/70R14
Height: Front 212 mm (8.35 inch) / Rear 264 mm (10.39 inch)
Tire size: 205/65R15
Height: Front 215 mm (8.46 inch) / Rear 266 mm (10.49 inch)
a. Front measuring point; measure from the ground to the center of the front side lower suspension arm mounting bolt.
b. Rear measuring point; measure from the ground to the center of the front side strut rod mounting bolt.
NOTE:
-
Before inspecting the wheel alignment, adjust the vehicle height to the specification.
-
If the vehicle height is not to the specification, try to adjust it by pushing down on or lifting the body.
2. Install camber-caster-kingpin gauge onto vehicle or position vehicle on wheel alignment tester.
NOTE: Follow the specific instructions on the equipment manufacturer.
3. Inspect Camber.
Camber: -0° 42' ± 45' (-0.7° ± 0.75).
Left-right error: 45' (0.75°) or less.
CAUTION: Camber is not adjustable, if the measurements are not within the specification, inspect the suspension parts for damaged and/or
worn-out parts and replace them as necessary.
Measuring Point Reference
4. Inspect Toe-In.
Toe-in (total)