toyota Workshop Repair Guides

Toyota Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 5
background image

Secondary Locking Device

b

Push the secondary locking device or terminal retainer into the full lock position.

5. Connect Connector

Continuity and Resistance Check

Continuity And Resistance Check

a. Disconnect the battery terminal or wire so there is no voltage between the check points.
b. Contact the two leads of an Ohmmeter to each of the check points.

Continuity And Resistance Check

If the circuit has diodes, reverse the two leads and check again.
When contacting the negative lead to the diode positive side and the positive lead to the negative side, there should be continuity.
When contacting the two leads in reverse, there should be no continuity.

Continuity And Resistance Check

c. Use a Volt/Ohmmeter with high impedance (10 K Ohms/Volt minimum) for troubleshooting of the electrical circuit.

Finding A Short Circuit

Transmission and Drivetrain > Sensors and Switches - Transmission and Drivetrain > Sensors and Switches - A/T > Overdrive Switch, A/T > Component Information > Diagrams > Diagram Information and Instructions > Page 5147

< PREV PAGE NEXT PAGE >