Camry Sedan L4-2.0L (3S-FE) (1987)
Evaporator Case: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect negative cable from battery.
2. Discharge refrigeration system.
3. Disconnect suction tube from cooling unit outlet fitting.
4. Disconnect liquid tube from cooling unit inlet fitting
NOTE: Cap the open fittings immediately to keep moisture out of the system.
5. Remove grommets from inlet and outlet fittings.
6. Remove glove box.
7. Disconnect connectors.
8. Remove three nuts and four bolts and remove cooling unit.
INSTALLATION
1. Install the cooling unit with three nuts and four bolts.
2. Connect connectors.
3. Install glove box and reinforcement.
4. Install grommets on inlet and outlet fittings.
5. Connect liquid tube to cooling unit inlet fitting.
Torque the nut.
Torque: 13 Nm (10 ft-lb)
6. Connect suction tube to cooling unit outlet fitting.
Torque the nut.
Torque: 32 Nm (24 ft-lb)
7. If evaporator was replaced, add compressor oil to compressor.
Add 40 - 50 cc (1.4 - 1.7 fl.oz.)
8. Connect negative cable to battery.
9. Evacuate air from air conditioning system.
10. Charge air conditioning system with refrigerant and check on gas leakage.
Specified amount: 600 - 750 g (1.3 - 1.7 lb)