Camry Sedan L4-2.0L (3S-FE) (1987)
7. INSTALL BOLTS IN VALVE BODY
NOTE: Each bolt length (mm) is indicated in the figure. Finger tighten the all bolts first. Then tighten them with a torque wrench.
Torque: 100 kg.cm (7 ft.lb, 10 N.m)
5. (A140 E) CONNECT SOLENOID WIRING
a. Connect the No. 1 solenoid connector. (white and shorter wire)
b. Connect the No.2 solenoid connector. (black and longer wire)
6. PLACE MANUAL VALVE AND BODY ON TRANSMISSION
a. Align the manual valve with the pin on the manual shift lever.
b. Install the manual valve body into place.